VADDIO CCU 300 Manual de usuario descargar pdf (Pagina 26)

Call 800-572-2011

Toll F

ree

vaddio

.com

Because the EZCamera cabling system uses Cat. 5 cabling for power,

video and control, only one type of cable and connector is required for the

installation, as opposed to running multiple cable types and miniature

din connectors. This system runs on passive baluns speciﬁcally designed

for standard deﬁnition cameras.

The main components of the EZCamera Cable System are the EZCamera

Cable Shoe, the Quick-Connect cable break out box and the PowerRite

power supply.

The EZCamera Shoe, which ﬁts on the back of the camera, regulates

the voltage to the camera, converts the native connectors (i.e. 8-pin mini

dins, 4-pin mini din, RCA-F and power jack) to standard RJ-45 jacks and

transforms the video signal for use over Cat. 5 cabling.

The Quick-Connect Box is a small break out box that connects to the

Shoe with a single cat. 5 cable for both power and video. The PowerRite

power supply is plugged into the Quick-Connect box, providing power

and returning S-Video and composite video back to the camera.

Depending on the type of camera used, power and video can be run

over a single Cat. 5 cable from 115-feet (35.05m) to 300-feet (91.44m).

Control cabling with the EZCamera system is run on a second Cat. 5, and

depending on wiring conﬁguration, can be run up to 700-feet (213.36m).

The Long Range EZCamera System (LR) was developed for the DomeVIEW

line of security enclosures used with the EVI-D70. The LR system

transports power to the camera and composite video from the camera up

to 300-feet when the Quick-Connect LR and PowerRite LR are co-located.

The LR system can extend up to 1000-feet (305m) when the PowerRite

LR is located within 200-feet (60.96m) of the camera. (See page 28).

One of the most popular additions to the EZCamera Cabling System is the

Quick-Connect 4 Video, Power & Control Wiring center. The Quick-Connect

4 is essentially four PowerRite Power supplies, four Quick-Connect break

out boxes and four EZCamera control adapters built-in to a 2-RU rack

mount enclosure. The Quick-Connect 4 centralizes all the video, power

and control cabling, and is a professional approach to cable management

for up to four single chip PTZ cameras.

Vaddio EZCamera Cable

™

Systems allow integrators to install and operate standard definition robotic PTZ

camera systems easily by using Cat. 5 cabling to extend the PTZ camera’s power, video and control capabilities.

EZCamera Systems

Model 100 Quick-Connect 4 Conﬁguration

WallVIEW 100 PTZ Camera System

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

Comentarios a estos manuales

Sin comentarios

VADDIO CCU 300 Manual de usuario Pagina 26

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad VADDIO CCU 300